|
ChurchRite
products are
sold by a Dealer Network .
Become a Dealer for ChurchRite! Get Started Today!
Free
Information
Did You
Know?...
As always, remember
to remove heating equipment from the water before touching or
entering the water. Although our equipment is safe, common
sense indicates the importance of removing the heater first.
CAUTION!
All Heater
Products must be protected by a GFCI Breaker before you use
them! This simple procedure will protect your Pastor and
Candidates during the Service! Make
sure your electrician installs a GFCI breaker. Some of
our heaters have one already installed.
|
ChurchRite®
- Our Portable Baptistry Heater Products
1.
Immersion Baptistry Heaters #10 - Non-Adjustable Immersion Heaters are well suited
for installations where it is difficult to provide plumbing to
and from the baptistry. We offer two styles of immersion
heaters. At the right is the #10 immersion water heater,
suitable for heating portable pools up to 150 gallons only.
Operating on 115v (standard household current), the heater has a
15' power cord with a built in GFCI plug.. Designed for safe, easy use, the #10 baptistry
heater features a ceramic heating element, preset thermostat at
90 F, and silicone bumpers so you can lay it down in the
portable baptistry. This is an Energy Efficient model, using 1/3
the power of other models. It will take 12-24 hours* to heat a
portable baptistry.
Additional Info.
To order, visit a
ChurchRite dealer.
2.
Immersion Heaters with Adjustable Thermostatic - 240V or
120V
The IMER
120V or 240V heaters are the other choice in immersion style
baptistry heater technology. Designed to heat either a
portable baptistry (120V) or full size baptistry (240V) these
units have been used by churches for over 30 years! This
design is very simple to use, just plug the heater into a GFI
protected outlet, put into the water, and turn the thermostat
knob until the light comes on. (Be sure heater is in the water
before turning on!) The 120V heater will raise the water
temperature to a suitable range in 12-24 hours*, and the 240V
unit will raise an average baptistry (500 gallons) in 6-8
hours*.
Additional Info. To order,
visit a
ChurchRite dealer.
3. New Poolside Baptistry
Heater! ENERGY SAVER!
This new baptistry heater is our most economical to operate! The
heater is mounted for easy use and accessibility, then attaches
to the 2 15' long garden hoses (included), which
extend into the pool. No drilling or plumbing needed! One hose
connects to the commercial grade 1/6 HP submersible pump which
pumps the water from the pool to the heater, then back again
into the pool. The submersible pump plugs into the back of the
heater unit so all are under the protection of the GFCI plug
(included with the 120V system - you provide with the 240V
system). PL120 heats PORTABLE
BAPTISTRIES up to 150 gallons. PL240 heats
baptistries up to 750 gallons. The PL240 uses 30% less energy
than other circulation systems!
Additional Info. To order,
visit a
ChurchRite dealer.
*Exact temperature increase times
cannot be given because there are other factors that affect
this, such as the initial water temperature, room ambient
temperature, and whether you have a
baptistry cover
on or not.
|
